KNX power supply 160 mA
Control Module - 2021-08-24
REG enclosure 4 TE
ETS product family system device
Product type power supply
Intended use Supplying bus voltage
to KNX devices
Supplying DC voltage to devices
According to DIN EN 60715 Mounting on top hat rail in sub-distributors
Product features
With integrated choke Output for powering the KNX bus
30 V DC Output for powering additional equipment
Nominal current can be distributed to the output as required
Reset
button Short-circuit
proof Surge proof No-
load safety
Suitable for operation in systems with emergency power supply
Used for Potential-free signaling contact for operating and diagnostic messages
Can be connected in parallel with the same KNX power supply (up to the maximum short-circuit current)
ETS product family system device
Product type power supply
Intended use Supplying bus voltage
to KNX devices
Supplying DC voltage to devices
According to DIN EN 60715 Mounting on top hat rail in sub-distributors
Product features
With integrated choke Output for powering the KNX bus
30 V DC Output for powering additional equipment
Nominal current can be distributed to the output as required
Reset
button Short-circuit
proof Surge proof No-
load safety
Suitable for operation in systems with emergency power supply
Used for Potential-free signaling contact for operating and diagnostic messages
Can be connected in parallel with the same KNX power supply (up to the maximum short-circuit current)
Technical Specifications
| standard: | AC 200 ... 240 V ~ |
| Mains frequency: | 50/60 Hz |
| Power loss (max load of all outputs): | 1.5 watts maximum. |
| efficiency: | about 76% |
| standard: | DC 240 ... 250 V |
| KNX | |
| KNX media: | TP 256 |
| Output voltage bus: | DC 28 ... 31 V SELF |
| Output current: | 160 mA (all outputs) |
| Short circuit current: | 1 A max |
| Running in parallel with the power supply: | Yes |
| message output | |
| Switching voltage AC: | AC 12 ... 230 V ~ |
| Switching voltage DC: | DC 2 ... 30 V |
| Switching current: | 5 mA... 2 A |
| Ambient temperature: | −5 ... +45 °C |
| Storage/Transportation Temperature: | −25 ... +75 °C |
| Relative humidity: | 93% max (non-condensing) |
| Installation width: | 72mm (4TE) |
| Connection Type: | screw terminal |
| Twist together finely with the ferrule: | 1 x 0.5 ... 2.5 mm² |